2012-03-11 Van Improvements -and- Correction of Battery Wiring

2012-03-11 Sunday.
((Press <Ctrl>-key and <+>-key at the same time to make the type larger. To undo the large type, press the <Ctrl>-Key and <->-keys at the same time.))
Van construction – (1) wall board between van fiberglass insulation wall and bed, and (2) boards to hold microwave to top of refrigerator. <NOTE: An out-of-scope project, that evolved, was to repair my electrical battery connections that did NOT have fuses, with 4 in-line 30-amp fuses.>

My older son, Joe, agreed to help me with a couple of van upgrades that I was reluctant to do myself. He came home on Sunday afternoon and we unpacked ALL of my STUFF from the van so that we could
(1) put a white wall board behind the driver side in front of the fiberglass insulation and (2) install a couple of cut 2″x4″ boards on top of the refrigerator to hold the microwave on top. (Note: I had driven the van without a tie-down on the microwave and on a sharp turn, the microwave fell on the carpet.)
After we removed all of the things out of the van, he cut the white wall board over the wheel well and gas tank pipe and we installed the bed against the board to press the insulation. Yes, I know, the insulation is less efficient when pressed – but, I need the aisle space. In addition to installing the wall board, Joe nailed the bed to the floor at the front and back posts.
Then, he asked about the battery and my wiring. I showed him the battery and he didn’t like my wiring AT ALL. I got a long lecture about how DANGEROUS my wiring was and he disconnected all of my electrical house equipment. When I worked on the wiring a while back, I couldn’t get the boat panel with fuses to work – so, I wired the reading 12-volt lamp, 2 dome lights, and the house radio to the battery. He was UPSET with me because I had NO FUSES for the case of wires breaking. I honestly didn’t realize that it was as dangerous as he told me – but, I’m just learning and am glad that he caught my error. We didn’t have any inline fuses, so he took a bare 30-amp fuse and soldered tails to both ends. Then, he crimped the wires from my 12-volt electrical house things to one end and attached the other end of the fuse to the battery. I always ‘test’ new wires and I turned on the light at the rear of the van. The light flickered on and then off. I knew that something was wrong, but re-wiring was ‘out-of-scope’ for the work planned for today. We continued on with the cutting of boards for the top of the refrigerator to hold the microwave. Joe hadn’t eaten much before coming to my house. For lunch, I had eaten a peanut-butter and jelly sandwich – so, I asked him if he would like one. He said ‘yes’ so I had a loaf of really good multi-grain bread and homemade apple jelly as well as organic peanut-butter. Good stuff – makes great sandwiches. Especially when you are hungry.
Back to the project, he finished and helped load the items back into the van. I was tired and decided that I would re-sort items inside tomorrow. He left and I was really happy to have accomplished all that we had today. I plan to go on a trip to Copperhill, TN at the end of the month and meet with the Yahoo Vandwellers_Construction Group.
The next day, I re-organized the interior and pondered more about the light that didn’t work. I checked the radio and other lights, and they didn’t work either. Then, I checked the fuse that Joe installed for me and it had a broken wire on the inside. Ah Ha! Blown fuse. I decided to remove the one fuse and install 4 in-line fuses. That way, if any of my 4 devices had an issue, I would know which one it was since the fuse for it would be blown. I live near a Harbor Freight Store and was surprised to find out that they sell fuses, but not fuse holders. Next, I went to Auto Zone and bought 4 in-line fuse holders that contained the 30-amp fuses. I had the other materials that I would need – so I thought. I disconnected the fuse that Joe installed, I opened the in-line fuses (cost about $2.99 each) and found the #12 wire size plastic-covered wire-crimping holders. UG – I don’t have #12 wire size plastic covered U-shaped terminals to screw into the battery post extender. Trip to nearby Lowe’s and back home with that U-shaped terminals as well as fertilizer, herb seeds, plastic-covers for utility room outlets, a 20-cup water filter system, some 2.5″ and 3″ screws to replace the ones that were used yesterday. Back to the project – I installed the fuses and took pictures of my NEW in-line FUSED battery connections and the inverter on top of the batteries. The batteries are in plastic, black boxes with covers and the inverter (Aimes 1200) sits on a shelf board on top of the batteries. I DO LOVE MY electrical system. It makes camping much more comfortable. Hopefully, I am now MUCH SAFER. (I am putting all of this information on my blog so that others who may want to install their own electrical system can learn from my mistakes and be safe with theirs. Please let me know if this information has been helpful.)

Image

ImageImage

Image

Image

Image

Image

Image

2012-02-29 Wednesday (Leap Year – Last Day in February) Breakfast at Betty’s Quik Stop in Bamberg, SC.

2012-02-29 Wednesday (Leap Year – Last Day in February) Breakfast at Betty’s Quik Stop in Bamberg, SC.
I LOVE Betty’s Quik Stop. It is a unique, family-run restaurant. The building used to be a Dairy Queen, and when I was in High School, there was no front dining area – just the window for ordering and back area. The owner posts signs all over and encourages others to put their pictures on the bulletin board. There is even a trophy on top of the case under a window. There are many potted plants with plastic bottles in use as a watering system. Dad and I ate a late breakfast and were the last to leave of the morning patrons. I have to admit that I went a bit overboard with the pictures, because I wanted to have different views and angles.

Speaking of photos, there used to be a filling station in Bamberg and the owner (Mr. Bochette) took Polaroid pictures of residents after they returned from hunting and/or fishing. The owner of the filling station retired and the photos are now at Betty’s Quik Stop. I found a picture of my Dad holding up a fish in the albums. It is a lot of fun looking at the photos displayed on the table.
While there, I didn’t take a photo of the grits, scrambled eggs, bacon and 2 slices of toast. When the food was served, I wasn’t in a picture taking mood – I was in an eating food mood. But, take my word for it, the food is good. But then, maybe you need to stop and try it yourself?

2012-02-19 to 2012-03-01 From Atlanta, GA to Bamberg, SC (to visit my Dad and older brother)

2012-02-19 Sunday to 2012-03-01 Thursday – from Atlanta, GA to Bamberg, SC to visit my Dad and older brother.
(Note: To make the type larger, press the <Ctrl key> and the <+ key> at the same time. To make the type smaller, press the <Ctrl key> and the <-key> at the same time.)
I intended to leave early in the morning, but it took longer for me to pack and I was late leaving. In the past blogs, I have put many words describing my trips – but, this time, I want to not write much and just post pictures of the town where I grew up. To understand the streets – and to get a good view of many town places, it is best to go to the web site maps.google.com and search for Bamberg, SC. I will post a few pictures that I took while there – and will include the main block of downtown and many of the business on Highway 301. Highway 78 travels through town from Charleston, SC to Augusta, SC and there used to be a railroad track parallel to the road. In the last 10 years, the railroad track has been abandoned and the city has created a walking path in its place. If you enjoy this blog, please put your feedback on it as it will let me know whether or not I should continue putting information like this on the web.

Image

Image

ImageImageImageImageImageImageImageImageImageImage